With this app, you can connect a mobile device to drone flight controllers via Bluetooth to adjust parameters. Includes Bluetooth communication setup and parameter configuration features.
AppRecs review analysis
AppRecs rating 2.8. Trustworthiness 75 out of 100. Review manipulation risk 21 out of 100. Based on a review sample analyzed.
★★☆☆☆
2.8
AppRecs Rating
Ratings breakdown
5 star
39%
4 star
13%
3 star
14%
2 star
7%
1 star
27%
What to know
✓
Low review manipulation risk
21% review manipulation risk
⚠
Ad complaints
Many low ratings mention excessive ads
⚠
High negative review ratio
34% of sampled ratings are 1–2 stars
About SpeedyBee App
SpeedyBee is an Appllication for Flight controller parameters settings.
Communication between mobile devices and flight control boards can be achieved through Bluetooth, you can use mobile devices to set the parameters of the flight controller.Any Bluetooth module compatible with your mobile device can be used, but if using the SpeedyBee Bluetooth-UART Adapter, this Bluetooth module will deactivate and activate automatically according to the status of the drone(armed/disarmed), no Bluetooth signal interference during the flight.
Flight Controller Requirements:
Betaflight firmware version ≥ 3.1.0
iNav FC version ≥ 1.8.1
Butterflight firmware version ≥ 3.1.0
System Requirements : iOS 13.0+
Instructions for use：
1.Connect the Bluetooth PCB with the UART interface of the Flight Controller, or use the flight controller integrated Bluetooth.
2.Open the Betaflight Configurator, on the Ports tab, open the Configuration/MSP port of the Bluetooth PCB, for the Bluettooth module of BLE4.0, 19200 is the recommended baud rate value.
3.Open the APP, connect the Flight Controller via Bluetooth, and you can adjust the parameters now.
Communication between mobile devices and flight control boards can be achieved through Bluetooth, you can use mobile devices to set the parameters of the flight controller.Any Bluetooth module compatible with your mobile device can be used, but if using the SpeedyBee Bluetooth-UART Adapter, this Bluetooth module will deactivate and activate automatically according to the status of the drone(armed/disarmed), no Bluetooth signal interference during the flight.
Flight Controller Requirements:
Betaflight firmware version ≥ 3.1.0
iNav FC version ≥ 1.8.1
Butterflight firmware version ≥ 3.1.0
System Requirements : iOS 13.0+
Instructions for use：
1.Connect the Bluetooth PCB with the UART interface of the Flight Controller, or use the flight controller integrated Bluetooth.
2.Open the Betaflight Configurator, on the Ports tab, open the Configuration/MSP port of the Bluetooth PCB, for the Bluettooth module of BLE4.0, 19200 is the recommended baud rate value.
3.Open the APP, connect the Flight Controller via Bluetooth, and you can adjust the parameters now.
